HPC Support

In this support section you will learn how to install the HPC Face Panel and connect to Wi-Fi.

  • Mounting Controller
    All necessary hardware is included for indoor and outdoor installations.Use the hole at the top of the controller as a reference and secure a 1" (25 mm) screw into the wall. Note:
  • Connecting AC Power
    The outdoor model HPC comes with a pre-installed plug to allow the controller to plug in to an outlet easily.  In the event you need to hard wire (wire directly to 120 VAC), the
  • Station Module(s)
    The HPC Controller is supplied with a factory-installed base module for up to 4 stations. Additional modules may be added in increments of 3 stations (PCM-300), 9 stations (PCM-900
  • Station Wire(s)
  • Master Valve/Pump Start Relay
    Complete this section only if you have a Master Valve installed. Hydrawise controllers work with a normally closed master valve, typically installed at the supply point of the main
  • Connecting Sensors
    HPC Controllers with date codes of JAN 2023 and newer include two sensor inputs. The SEN-SEN terminals from the original HPC Controllers have been split into SEN and SEN-2 to
  • Connecting to Wi-Fi
    From the Home screen, touch the Settings button and then the Wireless button.Select your wireless network from the list shown on the controller display and press the Confirm button
  • Connecting to Wi-Fi
    From the Home screen, touch the Settings button and then the Wireless button.Select your wireless network from the list shown on the controller display and press the Confirm button
  • Connecting a Remote
    The HPC Controller is compatible with Hunter remote controls. The SmartPort Wiring Harness (included with all Hunter remotes) allows for fast and easy use of Hunter controls.
  • Retrofit Your Pro-C Controller
    Ensure you have a strong Wi-Fi signal. Wi-Fi coverage can be easily tested using a smartphone. A signal strength of two or three bars is recommended. Wi-Fi connectivity can also be

Find Hunter