ICC2 - Advance Programming

FeatureStepsDescription
PROGRAMMABLE SENSOR OVERRIDEHold - and turn to START TIMESSets individual stations to ignore sensor shutdowns. Use + or - to select or deselect stations.
CYCLE AND SOAKHold + and turn to RUN TIMES. Enter Cycle, press PRG to set SoakSets max time a station can run at once, and minimum time it must wait before another cycle.
Divides run time into segments to prevent runoff.
DELAY BETWEEN STATIONSHold - and turn to RUN TIMESInserts a delay (seconds or minutes) between stations in a run time, for slow valves or recharging tanks.
HIDE PROGRAMSHold - and turn to WATER DAYSUse + / - to change from 4 to 1 to hide extra programs. 1 will show only program A,
start time 1. 4 will show all programs and start times.
SOLAR SYNC DELAYHold + and turn to SOLAR SYNCSet number of days before Solar Sync begins adjusting run times. Allows landscape establishment for a
set period of days, before Solar Sync begins adjusting automatically.
CLIK DELAYHold + and turn to OFFSet number of days for watering to remain off, after sensor has been activated and restored.
TOTAL RUN TIMETurn to RUN TIMES.
Press ◄ when station 1 is shown,
PRG to select other programs.
Calculates and displays total of all run times in a program start time.
TEST PROGRAMHold PRG 3 secs.Runs all stations in controller for the time entered for test or diagnostic purposes.
EASY RETRIEVEHold + and PRG to Save
Hold  - and PRG to Restore
Saves all program information to restore at a later time.
TOTAL RESETPRG and RESET buttonErases all watering information.
QUICK CHECKHold +, –, ◄, ►, together. Press + to begin check.Checks all stations for wiring problems.
RUN PROGRAMHold ► and press PRG to select program. Press ► to advance stations.Runs all stations in selected program; use ► to advance to next station manually.

 

 

Still need help? We're here.

Tell us what you need support with and we'll find the best solution for you.

Contact Support