Welcome Page Body
Welcome to the Remotes Support section. Here you will find informative videos and owner's manuals with instructions for installing and operating your Hunter irrigation remote.
Section Menu
Owner's Manual
-
Owner's Manual's
The Remote Owner's Manual will guide you through the installation, wiring, and operation of each of the irrigation remotes.Roam Owner's ManualRoam XL Owner's ManualICR Owner's
Installation
Changing Address
-
Roam
Both the ROAM Transmitter and Receiver have an “address” that they use when communicating. If the addresses do not match, the receiver will ignore the transmission. Your ROAM comes
-
Roam XL
Your ROAM XL System is pre-addressed to work right out of the box. However, if you changed the Transmitter address as described in the section, Preparing the Transmitter For Use",
Maximum Station Number
-
Roam
Your ROAM Transmitter comes from the factory with the maximum station number set to 15. This means that when you use the UP and DOWN buttons to change the station, you may change
-
ICR
Your ICR Transmitter comes from the factory with the maximum number of stations set to 9. This means that when you use the UP or DOWN buttons to change the station, you may change
-
Roam XL
The ROAM-XL Remote offers two separate modes with different station counts. This should be set based on the controller model.ControllerModeX-CorerE (Residential Mode)PRO-C/HPCrE
Operation Videos
Troubleshooting
-
Reset Roam XL
Power must be removed from the transmitter by removing at least one AAA battery from the battery compartment on the back of the unit. Press both the On and Off buttons
-
ERR Messages
When using a ROAM, ROAM-XL, ICR, or SRR remote, you may come across a controller that gives you an ERR or SP ERR message. There are two reasons that would cause one of these