Solar Sync - ACC Wiring

Installation Procedures

The ACC Controller is programmed with Solar Sync technology and therefore does not require the Solar Sync module.

Installing the Wired/Wireless Solar Sync Sensor

Simply mount the Wireless Receiver using the supplied brackets to mount the Wireless Receiver on the wall. Depending on the installation, the supplied 1.5" (3.8 cm) extender may be required. Route the wires from the Wireless Receiver into the controller cabinet.

  1. Make sure the power to the controller is turned off
  2. Connect the black Receiver wire to the black “ET” terminal on the master module
  3. Connect the green Receiver wire to the green “ET” terminal on the master module


Solar Sync Connecting to ACC

NOTE: Solar Sync will apply a default seasonal adjust value of 100% until the first full day (24 hour period) of weather measurements have been received from the sensor.

Still need help? We're here.

Tell us what you need support with and we'll find the best solution for you.

Contact Support

Find Hunter